Periphery · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
A JCM800 can't quite do a 5150 djent wall, but the High input cranked with scooped-ish mids and heavy presence gets tight, aggressive drop-C chug. Bridge ProBucker, both controls wide open, no ambience available.
Gaps between chugs ring with high-gain hiss instead of going silent.
Workaround: Mute aggressively with the right palm and left-hand fingers; lift pick hand onto strings to kill gaps.
Low end stays looser and the preamp saturates less than the original tight djent tone.
Workaround: Trim Bass to 5 and pick closer to the bridge; keep Pre-amp maxed on the High input.
Open ringing riff chords lose a little depth behind them.
Workaround: Let open chords ring full value and use the room; the original mix was only 1.5%.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Jackson Juggernaut HT6 / PRS SE Holcomb (bridge humbucker) → Tube Screamer-style boost → Noise gate → Axe-Fx II 5150/6160-style high-gain amp model → Delay block → Reverb block → 4x12 impulse response
The riff's rhythmic displacement and machine-tight muting demand strong timing and right-hand control, even though the fretting shapes are simple.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings