Metallica · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD1 on the DSL40CR with the tone-shift button in gets close to the scooped, razor-tight Justice rhythm. Bridge ProBucker full up, no reverb, all downstrokes. No TS-9 or gate on hand, so mute discipline does the gating.
Low end is looser and the chug less focused without a boost tightening the preamp.
Workaround: Lower bass to 4-5, resonance to 3, and keep gain near 6 so the amp stays articulate.
Gaps between staccato chugs ring and hiss instead of going silent.
Workaround: Mute with the fretting hand and palm immediately after each chug; roll bridge volume off between riffs.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge (EMG 81)
ESP MX-220 Explorer (EMG 81 bridge) → Noise gate → Ibanez TS-9 (if used) → Mesa/Boogie Mark IIC+ preamp (lead channel + graphic EQ) → Modified Marshall JCM800 2203 power amp → Marshall 1960 4x12 cab
The riff demands stamina-heavy pure downpicking locked to shifting meters over a nine-minute arrangement; sloppiness is instantly exposed by the dry, gate-tight tone.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings