Metallica · settings for Epiphone Les Paul Standard + Line 6 Helix Floor (direct)
Kills hum between stop-start riff blocks.
Subtle attack evening.
Tightener only, not extra gain.
80Hz +5, 240Hz -3, 750Hz -7, 2.2kHz +5, 6.6kHz +5, high-pass 80Hz.
Helix direct Justice-era thrash: Scream 808 as a tightener into Cali Rectifire with a scooped V-curve EQ, no ambience. ProBuckers are lower output than EMGs, so gain and a compressor make up the attack.
Without a mid dip the tone loses the scooped Justice voicing and sounds boxy.
Workaround: Use the Helix EQ block post-amp with a cut around 600-750Hz and a tight low cut.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (EMG 81)
ESP MX220 Explorer (EMG 81 bridge) → Ibanez TS-9 Tube Screamer → Mesa/Boogie Mark IIC+ head (lead channel + graphic EQ) → B&B Audio/Aphex EQF-1 in effects loop → Marshall 4x12 cabinet
The riff is nonstop downpicking at high tempo with precise palm muting; stamina and timing are harder than the note content itself.
Every song already dialed in for the Line 6 Helix Floor.
Line 6 Helix Floor presets