Eric Johnson · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Tremolo Speed · Tremolo Intensity
A Twin Reverb stays clean, so the Marshall crunch must come from the amp's own edge-of-breakup plus a hot bridge humbucker. Set the Vibrato channel loud with dark treble, light reverb for the Echoplex ambience, and lean on picking dynamics for the violin sustain.
Without it there is no smooth compression or singing sustain; tone stays clean.
Workaround: Crank amp volume into breakup, dig in hard, and use bridge humbucker at full volume.
Fast lines lose the ambient blur that glues the cascades together.
Workaround: Use amp reverb at 2-3 as a short ambience substitute.
Loses occasional parked filter colour on a few lead phrases.
Workaround: Roll the bridge tone knob down slightly for a similar mid-focused filter.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup on both guitars
1963 Gibson ES-335 / 1954 Stratocaster → Dunlop Cry Baby wah → Maestro Echoplex EP-3 → Paul C./Chandler Tube Driver → 1969 Marshall 1959 Super Lead 100W (channels linked with Y-cable) → Marshall 4x12 cabinet
The solo demands Johnson's economy-picking cascades and 'bounce' upstroke touch at speed; tone depends as much on right-hand control as on gear.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings