Radiohead · settings for Squier Stratocaster + Boss Katana (50/100 MkII, Gen 3)
At zero: Mod · Fx · Delay
Green variation, Booster knob 4, stacked into Crunch.
Green spring type, Reverb 2.
Katana Crunch mode with the Booster pushed to mimic the ShredMaster's British grit over a sterile clean amp. Bridge pickup, volume full, tone rolled back slightly. Light reverb only; no delay. Ceramic single-coils need a touch more gain than the Lace Sensors.
Its contour-shaped British grit is the chorus sound; the Katana Crunch plus Booster is close but less raspy.
Workaround: Crunch mode with Booster at 4 and middle at 6, picking hard for the stab attack.
No instant clean/dirty A/B between two amp paths.
Workaround: Store Crunch+Booster in one Katana channel memory and a Clean patch in another, switch by footswitch or guitar volume.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (Lace Sensor) for the crunch stabs; neck/middle for the clean verse layer
Fender Telecaster Plus → Demeter Tremulator TRM-1 (clean path) → EHX PolyChorus (clean path) → Boss LS-2 Line Selector → Marshall ShredMaster (distorted path) → Fender Eighty-Five combo (clean channel) → 1x12 combo speaker
Amp effects: reverb (Fender Twin Reverb spring reverb was Greenwood's only reverb in this era and used only on clean playing; the Eighty-Five's own reverb, if used, was set low)
The chords are beginner-friendly; the challenge is the dynamic contrast and nailing the violent muted-string attack that launches each chorus.
Every song already dialed in for the Boss Katana (50/100 MkII, Gen 3).
Boss Katana (50/100 MkII, Gen 3) settings