Avenged Sevenfold · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD2 on the DSL40CR gets close to the Uberschall's tight high gain. Bridge ProBucker, mids up, tone shift off, reverb off. Without a boost or gate you must mute with both hands.
Hiss and string noise fill the staccato gaps, blurring the riff's stops.
Workaround: Mute with the picking-hand palm and left-hand fingers on every stop; roll guitar volume down between phrases.
Slightly looser low end and less cutting sustain than the record.
Workaround: Lower bass to 4 and raise middle/presence slightly to mimic the tightening.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Schecter Synyster Gates Custom / S-1 (Seymour Duncan Invader bridge) → MXR Boost/Line Driver → Noise gate → Bogner Uberschall head → Bogner Uberkab 4x12
The riff is intermediate: not technically exotic, but demands clean right-hand muting and tight timing to match the record's percussive feel.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings