Slayer · settings for Epiphone Les Paul Standard + Boss GX-100 (direct)
Before amp: low cut 80 Hz. Broad boost +3 dB at 800 Hz, Q approximately 0.7. Remaining bands flat.
On a 0–100 scale: gain 58, bass 42, middle 64, treble 58, presence 54. Set level for comfortable output without clipping.
Start threshold at 30/100 and release at 45/100. Raise threshold only until muted-string hiss stops.
Enable speaker simulation. Select the closest available British-style 4×12. Start with centered mic settings. Low cut 80 Hz and high cut 7 kHz where available.
Use the GX-100’s X-Hi Gain model with a modest preamp mid boost and a British-style 4×12 cab. Keep the ProBucker bridge pickup unsplit for thick, biting rhythm distortion, with enough restraint in the gain and bass to preserve the riff’s attack.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker, inferred
B.C. Rich V, likely → Boss RGE-10 graphic equalizer → Marshall JCM800 2203 100W
Technique: Palm muting contrasted with ringing notes, Sustained-note vibrato
Moderate technical demands; clean execution depends on muting and preserving the contrast between chugging and sustained notes.