Paramore · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume
Classic Gain channel in Crunch mode gives the mid-forward British crunch of Farro's JCM2000 DSL. Bridge ProBucker, guitar wide open, mids pushed, resonance for drop C# tightness. No drive or delay pedals owned, so amp reverb covers minimal ambience.
Loses the eighth-note width on the clean hook; the driven riff stays drier than the record.
Workaround: Play the riff dry and let the amp reverb at 2 supply a hint of space.
Slightly less low-end tightness and front-end compression on the drop-tuned riff.
Workaround: Lower bass to 4.5 and raise middle; the Crunch mode supplies the needed grit alone.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker for the driven riff; neck or middle for the clean intro figure
Gibson Les Paul Classic → Overdrive (unspecified boost) → Boss DD-20 Giga Delay → Marshall JCM2000 DSL 100 → Marshall 1960A 4x12
Technically modest: the riff is simple drop-tuned power chords, but keeping the clean intro figure even and switching tones cleanly takes control.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings