Pantera · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
Dime's scooped, tight Randall tone on a JCM800 with no pedals: High input, preamp maxed, scooped but not gutted mids, bridge ProBucker. Expect a raspier, looser, less saturated version without an EQ boost and noise gate.
Missing gain push and deep scoop; stock 800 is looser and less saturated.
Workaround: Max preamp, middle around 4, and raise master for power-tube compression.
Less upper-mid attack and push.
Workaround: Lean on presence and treble; pick hard near the bridge.
Hiss rings through the stop-start silences.
Workaround: Mute strings with both hands and roll guitar volume down during long breaks.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge
Dean ML (1980s, tobacco sunburst, Floyd Rose) → Hush 2-B → Six-Band Graphic EQ (M-109) → PQ-4 Parametric EQ → M-126 Flanger/Doubler → Randall Century 200 (C200) solid-state head → Randall 4x12 (412JB / 412CB type)
Not fast, but the riff demands precise muting and groove in a very low tuning.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings