Nirvana · settings for Epiphone Les Paul Standard + Line 6 Helix Floor (direct)
Level unity, light squash for broken-amp sag.
Level unity - SansAmp stand-in.
Master low.
Single dynamic mic, low cut 80Hz, high cut 7kHz.
Decay short - just room, not ambience.
Going direct through the Helix: US Double Vib set clean-ish and compressed, with a low-drive DS-1-style block standing in for the SansAmp Classic. Bridge ProBucker, guitar tone rolled back slightly for the restrained, gritty edge-of-breakup verse riff.
The SansAmp's speaker-emulated, compressed grit is the core of the verse dirt.
Workaround: Classic Distortion block at low drive into the US Double Vib with a compressor gets very close.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge
Univox Hi-Flier → Tech 21 SansAmp Classic → Electro-Harmonix Polychorus → Fender Quad Reverb (4x12 Utah speakers, one blown)
The riff is easy to fret; the challenge is holding back in the verse and getting the explosive chorus contrast from picking and a gain switch.
Every song already dialed in for the Line 6 Helix Floor.
Line 6 Helix Floor presets