The Long Faces · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
A JCM800 through the High input gives the bright British crunch this lead needs. Bridge single-coil, preamp around 6, mids pushed, master as loud as allowed. No pedals owned, so the amp's own crunch covers the overdrive and the delay/reverb ambience is missing.
Lead sits drier and closer to the band instead of floating above it.
Workaround: Play in a live room, hold notes longer and use wide vibrato to fake sustain and space.
Tone is dry; the JCM800 has no onboard reverb.
Workaround: Lean on room acoustics and sustained bends for perceived ambience.
Without a boost the single-coils may not sustain as much as the original lead.
Workaround: Use the High input with preamp at 6.5 and pick harder; amp crunch covers most of it.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker or bridge single-coil, bright and cutting
Electric guitar (bridge pickup) → Transparent overdrive → Short delay → Amp (clean-to-crunch combo) → Speaker cabinet
Amp effects: reverb (Assumed light spring/plate ambience; could equally be studio reverb — no source confirms an amp model.)
A melodic, moderate-tempo lead; the challenge is expressive phrasing and note placement rather than raw speed or technique.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings