Rage Against the Machine · settings for Squier Stratocaster + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
JCM800 territory is native to the DSL40CR. Use Ultra Gain OD1 with mids pushed, tone shift off, bridge single-coil, and let the amp alone make the distortion. No pedals needed for the main riff.
No octave-up dive squeals, used in the solo/noise sections rather than this riff.
Workaround: Fake dives with behind-the-nut bends and tremolo-bar-style string pushes above the nut.
No parked mid-honk for fills; riff itself is unaffected.
Workaround: Push Middle higher and favor the bridge pickup for a cocked-wah bark.
No oscillating echo textures; the main riff was dry anyway.
Workaround: Leave it out, the riff needs silence between hits.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge for the main riff
Fender Telecaster (bridge pickup, drop D) → Marshall JCM800 2205 preamp (boost channel) → Cry Baby Wah (effects loop) → DigiTech Whammy WH-1 (effects loop) → Boss DD-2/DD-3 delay (effects loop) → MXR Phase 90 (effects loop) → JCM800 power amp → Peavey 4x12 with G12K-85s
The notes are simple; the challenge is groove accuracy, muting the dead space, and keeping a high-gain amp quiet between hits.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings