Ratt · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
A JCM800 2203 into a Les Paul bridge humbucker is essentially the record's modded-Marshall half. Push the preamp high, treble up, mids present, and get the master loud enough for power-tube compression. No pedals needed.
Riff sounds drier and narrower than the record's wide mixdown ambience.
Workaround: Add short plate reverb and a 70-90 ms slap in your DAW/interface rather than at the amp; the raw amp tone is correct.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Charvel San Dimas superstrat (bridge humbucker) → Marshall 100W head / Fender Super Champ (blended) → Marshall 4x12 and open-back Orange 4x12 with EV speaker → Console reverb/delay at mixdown
The riff itself is straightforward in E standard, but the groove demands clean muting, even attack and tight rhythmic placement to sound like the record.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings