Tame Impala · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
A JCM800 into low input with the preamp backed off gets the closest clean, chimey platform for this part. No modulation or delay is available, so the swirl and wash must be imagined; lean on neck+middle position and light picking.
The defining Tame Impala swirl is absent; the part sounds static and dry.
Workaround: Vary pick attack and use subtle volume-knob swells to create motion; sit the part behind the synths.
Loses the smeared width behind the eighth-note figure.
Workaround: Play slightly lighter and let notes ring into each other for a pseudo-smear.
The dry signal lacks the washy psychedelic ambience.
Workaround: Record with room mics or add reverb at the mix stage.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge/middle (position 4) for a glassy, chimey clean
Fender Stratocaster → Phaser (MXR Phase 90-style) → Analog/tape-style delay (Deluxe Memory Man-style) → Vox AC30 combo → Vox AC30 internal 2x12 → Plate/hall reverb (studio)
The physical part is simple, but matching the recorded tone depends on phaser, delay and studio processing rather than playing difficulty.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings