Audioslave · settings for Squier Stratocaster + Fender Hot Rod Deluxe IV
At zero: Drive · Master
2.5.
Clean channel on the Hot Rod Deluxe pushed near breakup, neck pickup, tone rolled slightly to tame the ceramic brightness. Light amp reverb for the studio room. The defining tremolo pulse has no source on this rig, so it's the one real gap.
Without tremolo the signature wave-like chop of the riff is gone; it becomes a plain clean arpeggio.
Workaround: Simulate the pulse by picking: swell and dip each eighth note with pick attack and volume-knob movement at roughly 4-5 pulses per bar at 75 BPM.
Loses a touch of depth under the riff; barely audible at the original's low level.
Workaround: Nudge amp reverb up to 3-4 to fake the slight tail.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck (Fender Noiseless single-coil)
Soul Power Stratocaster (neck pickup) → Marshall JCM800 2205 preamp (overdrive channel) → FX send → Boss TR-2 Tremolo → Boss DD-2 Delay → DOD FX40B EQ → FX return → Marshall JCM800 2205 power amp → Peavey 4x12 with Celestion G12K-85
The riff itself is a beginner-friendly repeating arpeggio; the challenge is even picking, clean-tone control and matching the tremolo rate to the tempo.
Every song already dialed in for the Fender Hot Rod Deluxe IV.
Fender Hot Rod Deluxe IV settings