Jeff Buckley · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
A JCM800 into low input with the pre-amp backed off gives a tight, bright clean. Neck single-coil, tone rolled slightly back to soften the Squier's ceramic edge, and a gentle midrange push to imitate the Vibroverb's warmth. No reverb on hand, so touch and sustain carry the part.
Arpeggios sound dry and close, losing the track's airy halo.
Workaround: Play in a live-sounding room, let chords ring full value, and use slow volume swells to fake decay.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck single-coil
1983 Fender Telecaster (neck pickup) → Alesis Quadraverb → Fender Vibroverb '63 Reissue → Combo 1x15 speaker
Amp effects: reverb (The '63 Vibroverb reissue has onboard tube spring reverb; the riff's natural ambience is credited to the amp.)
The shapes are manageable but the piece lives on touch, timing and dynamic restraint; sustaining the voicings cleanly under a demanding vocal is the hard part.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings