Ozzy Osbourne · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
Same amp as the original: JCM800 2203 on the High input with the preamp pushed hard. Without an SD-1, extra preamp gain and the bridge ProBucker get the sustaining, singing lead; a cheap Tube Screamer-style pedal would complete it.
Less sustain and saturation, and a looser low end.
Workaround: Raise the preamp toward 9 and the middle, and dig in with the pick.
Slightly narrower, drier image.
Workaround: Leave it out; its use on the original is uncertain.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Likely bridge humbucker; inference from Wylde's recording rig, not confirmed for this solo.
Gibson Les Paul Custom → Boss SD-1 Super Overdrive → Marshall JCM800 2203 100W → Likely Marshall 4x12 with 75W Celestions
Estimated playing difficulty; expressive control matters as much as speed.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings