Avenged Sevenfold · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
JCM800 High input, preamp cranked for a tight 80s-metal lead. ProBucker bridge, both knobs full. No pedals, so the amp's own preamp supplies all the saturation; delay, boost and gate are the main things missing.
Fast runs lose the 1/8-note trail and sound drier and smaller than the record.
Workaround: Lean on amp sustain and let notes ring into each other; a room mic or DAW delay can add trails when recording.
No lead level lift or extra front-end tightness; JCM800 alone is slightly looser and quieter for solos.
Workaround: Run preamp at 9 and keep guitar volume at 10; pick harder for push.
High preamp settings on a JCM800 hiss and squeal between phrases.
Workaround: Mute with the picking-hand palm and fretting-hand fingers; turn away from the cab to stop feedback.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Schecter Synyster Gates Custom (bridge Invader) → Dunlop Cry Baby Wah → MXR MC401 Boost/Line Driver → Noise gate → Visual Sound H2O (delay) → High-gain 100W head (Mesa Dual Rectifier / Bogner Uberschall) → 4x12 cab with Celestion Vintage 30s
A signature Gates shred solo: sweep picking, rapid scalar runs and tremolo-arm work demand clean right-hand sync and accurate muting at high gain.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings