Ozzy Osbourne · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume
Ultra channel.
Ultra Gain OD1 on the DSL40CR gets close to a boosted JCM800. Bridge ProBucker full up, mids kept in, tone shift off. No boost or chorus available, so gain and presence do the tightening work.
Less tightness and mid push into the preamp; palm mutes are looser.
Workaround: Raise middle and presence, keep Ultra gain near 6.5 and pick hard to compensate.
Loses the subtle stereo shimmer on sustained notes.
Workaround: Use wide vibrato and full sustain to keep long notes alive in mono.
Lead sounds drier and less three-dimensional.
Workaround: Amp reverb at 1.5 provides a little tail.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (EMG 81)
Gibson Les Paul Custom (EMG 81 bridge) → Boss SD-1 Super Overdrive → Boss CH-1 Super Chorus (stereo out) → Marshall JCM800 2203 heads (x2) → Marshall 4x12 with Celestion 75s → Yamaha SPX90 (mix ambience)
The lead starts melodically but escalates into rapid picked runs and Wylde's signature squeals; the real hurdle is matching his pick attack and vibrato rather than the notes alone.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings