Deftones · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
Bridge ProBucker into a JCM800 High input with preamp high gives a thick Marshall crunch-to-heavy wall; it falls short of JMP-1 OD2 saturation without a boost, so lean on volume, low tuning and sustain.
Clean layers lose width; heavy riff unaffected since chorus was bypassed.
Workaround: Play the heavy part dry; chorus is not used on the riff.
More hiss and hum between slow sustained chords.
Workaround: Mute strings with the palm and roll guitar volume off in pauses.
Less precise scooped, smooth tone shaping.
Workaround: Use the amp's middle and presence controls to scoop and smooth.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
ESP Stephen Carpenter signature 7-string → Marshall JMP-1 MIDI tube preamp → TC Electronic FireworX → Behringer Ultra-Q Pro PEQ2200 → Behringer XR2000 Intelligate → Marshall EL34 100/100 power amp → Marshall 1960B 4x12
The riff itself is easy; the challenge is patience, chord sustain and matching the thick low-tuned tone.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings