Nirvana · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
Clean jangly Rape Me riff on a JCM800 is a stretch: use the Low input, low preamp, coil-split bridge pickup and rolled-back guitar volume for an edge-of-breakup brightness. Mids pushed, bass trimmed, no reverb available.
Riff sounds drier and flatter than the record's light room spring.
Workaround: Play in a live-sounding room; the part is nearly dry anyway, so bare amp is close.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge/middle-ish single coil for the jangly clean riff; bridge humbucker when the chorus distortion hits
Veleno aluminum guitar (Univox Hi-Flier for chorus) → Boss DS-2 Turbo Distortion (off for riff) → Tech 21 SansAmp Classic (off for riff) → Fender Quad Reverb (spring reverb) → Built-in 4x12 Utah speakers
Amp effects: reverb (Quad Reverb has onboard spring reverb; a light amount suits the clean riff, though no documented dial position exists)
The riff itself is four easy chords; the challenge is the dynamic jump into the chorus and keeping the clean strum loose without getting muddy.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings