Bryan Adams · settings for Squier Stratocaster + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Tremolo Speed · Tremolo Intensity
A loud clean Twin can only hint at Marshall edge-of-breakup, so we push the Vibrato channel volume high for the first touch of power-stage grit, keep the bright switch off to tame ceramic single-coils, and add a touch of reverb for the record's room.
Without it the riff stays fully clean and loses the mid-push and grind that defines the part.
Workaround: Run amp volume at 7+ and dig in hard with the pick for compression; roll guitar volume back for chord stabs.
Loses the mid-'80s shimmer and width on the ringing open-string hook.
Workaround: Use the Vibrato channel's tremolo very shallow and slow for faint movement, or let the reverb supply width.
Loses the short 250 ms ambience behind the riff.
Workaround: Amp reverb at 2-3 fills a similar space at low mix.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (some players use bridge+middle for the ringing open-string hook)
1976 Fender Stratocaster → Ibanez TS-9 Tube Screamer → Marshall 100W head → 4x12 Celestion cabinet → Korg rack delay (studio/post) → ADA chorus (studio/post)
The riff is easy harmonically but demands even picking, muting control and the right tuning choice to match the record's ring.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings