Slayer · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
You have the exact amp. Run the High input, preamp up for saturation to make up for passive ProBuckers, mids forward, dry. Bridge pickup, everything on 10, and let the power tubes push.
Less front-end tightness and mid-cut; riff sits slightly softer and boomier.
Workaround: Push amp Middle to 8 and keep Bass at 4.5; pick hard near the bridge to tighten attack.
Hiss and hum fill the gaps between palm-muted stabs.
Workaround: Mute with the picking-hand palm and left-hand damping; roll guitar volume down between riffs.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Jackson Soloist (EMG 81 bridge) → 10-Band Graphic EQ → Noise gate → Marshall JCM800 2203 head → Marshall 1960 4x12 cabinet
The main riff is slow enough to learn quickly, but keeping the muted attack even and the right-hand down-picking consistent at volume is where it gets demanding.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings