Nirvana · settings for Squier Stratocaster + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Mid-forward crunch from the DSL40CR's Classic channel in Crunch mode, bridge pickup, tone shift off. Gain pushed a bit higher than usual to compensate for low-output ceramic single-coils, with bright treble and strong mids for that ragged In Utero bite.
Loses the compressed, slightly fizzy pedal-voiced saturation layered over amp breakup.
Workaround: Lean on Crunch mode with gain at 8 and full guitar volume; the Marshall's own breakup is the closest available compression and grit.
Less extra bite and aggression on the heaviest chord hits.
Workaround: Dig in harder with the pick and let the amp's Crunch mode compress on the accents.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge
Univox Hi-Flier Phase 2 → Tech 21 SansAmp Classic → Fender Quad Reverb (one working power tube) → Internal 4x12 Utah speakers
Simple shapes and a short chord set; the challenge is the sloppy-but-tight syncopation and dynamic control rather than technique.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings