Oasis · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Tremolo Speed · Tremolo Intensity
Epiphone Les Paul bridge humbucker into a loud clean Twin Reverb. Push the volume into early breakup, scoop less and boost mids, light spring reverb. Without a drive pedal the crunch is limited, so strum hard and lean on volume for thickness.
Without it the Twin stays clean; you lose the mid-hump crunch and sustain.
Workaround: Run volume high for amp breakup, middle at 8, and strum hard; double-track if recording.
Loses the short tape slap that thickened the rhythm bed.
Workaround: Leave amp reverb low; the slap is subtle and mostly inaudible in the mix.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker for the main chordal riff; neck for warmer sustained lines
1953 Gibson Les Paul Goldtop conversion → Ibanez TS808 Tube Screamer → Roland RE-201 Space Echo → Marshall Valvestate 80V 8080 → Combo 1x12 speaker
Amp effects: reverb (The Valvestate 80V 8080 has onboard spring-style reverb; used sparingly if at all, much of the ambience is studio plate/room from Monnow Valley.)
The riff is harmonically simple; the challenge is strumming feel, dynamics across six minutes, and getting enough thickness from a single guitar track.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings