Nirvana · settings for Epiphone Les Paul Standard + Marshall MG30GFX
Rate medium, FX Level 3.
Kurt's loud riff was a clean Mesa pushed by a DS-1. On the MG30GFX, use OD1 for grainy mid-forward crunch, bridge humbucker full up, mids pushed, bass trimmed, and a touch of chorus for the layered shimmer.
The signature grainy, slightly fizzy pedal dirt over a clean amp is replaced by solid-state amp distortion.
Workaround: Use OD1 with gain near 6-7 and mids high; keep bass low so the amp stays grainy rather than woolly.
Amp chorus is less deep and watery than the Small Clone's wide warble.
Workaround: Keep FX Level low so it thickens rather than wobbles the chords.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Fender Stratocaster (JB bridge humbucker) → Boss DS-1 → Electro-Harmonix Small Clone → Mesa/Boogie Studio .22 preamp (rhythm channel, graphic EQ in) → Crown Power Base 2 power amp → Marshall 1960B 4x12 with Celestion G12T-75
Technically easy; the challenge is clean DS-1 switching, consistent downstrokes and taming string noise between chords.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings