Muse · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
The original riff is a DI'd fuzz with no amp. With a Les Paul into a JCM800 and no pedals, get as close as possible: High input, preamp near max for a compressed, mid-forward buzz, master low-to-moderate, and hard palm muting for the gated sputter.
Without fuzz the riff loses its gated, synth-like buzz and sounds like plain amp distortion.
Workaround: Run High input with preamp near 10, middle maxed, and mute aggressively with the picking hand to fake the gate.
Loses the talking vocal-formant quality on the bent notes.
Workaround: Set Middle high and lean on the bridge tone knob for a parked-wah midrange.
Riff is slightly narrower and less thick than the record.
Workaround: Play very tightly; the effect was subtle and largely a mix widener.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge
Manson electric guitar (bridge humbucker) → Fuzz (DI'd, model unconfirmed) → Filter / wah sweep → Short delay / doubling → Direct to console (no amp or cabinet)
Notes are simple — open E alternating with a bent 10th-fret note — but the funk timing, muting and the gated fuzz tone are what sell it.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings