Pantera · settings for Squier Stratocaster + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD2 on the DSL40CR with mids scooped and gain pushed hard to compensate for low-output single-coils. Bridge pickup, everything wide open. No EQ boost or noise gate available, so pick tight and keep volume moderate.
Without the EQ boost the amp front end sees less level, so the riff is less saturated and less focused in the upper mids.
Workaround: Push gain_ultra higher and lift presence; use the tone shift button to carve the mid scoop.
Single-coils plus high gain hiss and hum loudly between the riff's stabs, blurring the syncopated silences.
Workaround: Mute with the picking-hand palm and fretting-hand fingers; roll guitar volume off during rests.
Loses the subtle hollow swirl of the layered stack; the riff still reads as dry and heavy.
Workaround: Skip it; the dry layer dominates the mix anyway.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Dean ML with Bill Lawrence L-500XL (bridge) → Rocktron noise gate → MXR Six Band EQ → Furman PQ-3/PQ-4 Parametric EQ → MXR Flanger (one stack only) → Randall Century 200 II head → Randall 4x12 cabinet
The notes are simple, but the swagger, muting tightness and the clean/heavy contrast are what make it sound right.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings