Metallica · settings for Epiphone Les Paul Standard + Fender '65 Deluxe Reverb Reissue
At zero: Reverb · Tremolo Speed · Tremolo Intensity
No effects needed for this part.
Justice-era scooped high gain on a 22W blackface clean amp is a stretch. Push the Normal channel into breakup with the bridge ProBucker, roll treble up and bass back for tightness, and accept a gritty crunch rather than saturated thrash chug until a distortion pedal is added.
Without it the riff is a crunchy clean-amp breakup, not saturated thrash; palm mutes lack sustain and density.
Workaround: Run volume 7 for power-amp grit, dig in hard and keep mutes very short so the attack reads as aggression.
No mid knob or loop, so the amp's native mid push stays; tone is more honky than the scooped album sound.
Workaround: Treble high, bass moderate and tone knob slightly back approximates a V-curve on this amp.
Lose the low-end tightening and front-end push that defines the chug articulation.
Workaround: Pick closer to the bridge and keep mutes tight to fake the compressed attack.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge (EMG 81)
ESP Explorer (EMG 81 bridge) → Ibanez TS-9 Tube Screamer → Mesa/Boogie Mark IIC+ preamp → Parametric EQ in effects loop → Modified 100W Marshall JMP/JCM800 power amp → Marshall 4x12 cabinet
Right-hand stamina and mute consistency matter more than the fretting; the long arrangement demands accuracy over nearly ten minutes.
Every song already dialed in for the Fender '65 Deluxe Reverb Reissue.
Fender '65 Deluxe Reverb Reissue settings