Megadeth · settings for Epiphone Les Paul Standard + Marshall MG30GFX
At zero: FX Level · Reverb
No effects needed for this part.
OD2 channel on the MG30GFX with a mid-forward EQ approximates the JMP-1 rhythm voicing. Bridge ProBucker full up, tone near full, dry and tight: no reverb, no delay. Gain kept just under max for articulation.
High-gain hum and string noise bleed between staccato stabs, blurring the chug.
Workaround: Mute with the picking-hand palm and fret-hand fingers; roll bridge volume back between phrases.
Less of the surgical 800Hz-1kHz push and 100Hz trim that makes the riff cut.
Workaround: Approximate with Middle at 7 and Bass at 4 on the amp panel.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Jackson King V (bridge humbucker) → Noise gate → Marshall JMP-1 preamp → Graphic EQ (loop) → Marshall EL34 100/100 power amp → Marshall 1960 4x12 cabinet
The notes are not fast, but Mustaine's swing-feel placement and razor-tight muting make the groove harder to nail than the tab suggests.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings