Slipknot · settings for Epiphone Les Paul Standard + Marshall MG30GFX
At zero: FX Level · Reverb
No effects needed for this part.
Drop-B chug tone from an MG30GFX: OD2 channel pushed hard, mids kept present rather than scooped, treble up for percussive attack. ProBuckers are lower output than EMGs, so gain sits higher and picking must stay tight.
Without the loop EQ the chugs lose the 3-4kHz bite and low-mid tightness.
Workaround: Approximate with amp treble up, middle moderate, bass restrained; roll bass back further if tuned to drop B.
High gain leaves hum and string noise between staccato stabs.
Workaround: Mute aggressively with palm and fretting hand; keep gain just below where hiss dominates.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Jackson custom King V (EMG bridge humbucker) → Rocktron Piranha preamp (modern distortion channel) → dbx 31-band graphic EQ in preamp effects loop → Rocktron HUSH noise gate (internal) → Mesa/Boogie 295 Simul-Class power amp → Carvin 4x12 with Eminence-made Carvin speakers
The shapes are simple power chords and single-string chugs; the challenge is picking-hand stamina and locking the syncopation cleanly at tempo.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings