Chris Isaak · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
Clean, glassy Strat lead through a JCM800 run on the Low input with low preamp and moderate master, scooped slightly, neck+middle pickups. Reverb and delay are missing and essential; buy a delay and reverb for the FX loop.
Without it the solo sounds dry and close, losing the lonely cavernous wash.
Workaround: Record dry and add a long plate reverb in a DAW, or play in a reflective room.
Sustained bends won't smear into the ambience.
Workaround: Add a 400 ms delay with 2-3 repeats in a DAW when recording.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck or neck+middle (estimated for the warm, hollow lead sound)
1965 Fender Stratocaster → 1964 Fender Deluxe (blackface) → Studio reverb (unit not documented) → Delay (unit not documented)
Amp effects: reverb (Only if the 1964 Deluxe was a Deluxe Reverb; sources do not say, and much of the ambience may be studio reverb.)
The notes are simple, but matching Wilsey's bar vibrato, intonation and restraint on a fully clean tone is the hard part.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings