Skid Row · settings for Epiphone Les Paul Standard + Boss Katana (50/100 MkII, Gen 3)
At zero: Booster · Fx
Chorus type, rate ~3, depth ~5, low-moderate level.
Dotted-eighth at ~90 BPM (~500 ms), feedback 2-3 repeats, low mix.
Room or plate, short decay, low level.
Glassy chorused clean arpeggios: Katana Clean mode, bridge humbucker, built-in chorus on the Mod knob and a light dotted-eighth delay, with a bright, slightly scooped EQ to emulate the MP-1 rack clean.
Pre-preamp shaping missing; minor tonal difference on clean part.
Workaround: Use Boss Tone Studio GEQ/PEQ block in the FX slot, or the amp EQ knobs.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Steinberger, EMG-equipped (forum claim) → PEQ-3 Parametric EQ → ADA MP-1 preamp (v1.0, unmodified) into McIntosh 2100 power amp → Vintage Marshall 4x12 with Celestion G12H 30W
Amp effects: chorus (MP-1 built-in stereo chorus; the audible wide chorus on the clean arpeggios is most likely this (rate ~3, depth ~5, estimated))
Simple chord shapes; the challenge is clean, even arpeggios and a convincing clean-to-crunch switch.
Every song already dialed in for the Boss Katana (50/100 MkII, Gen 3).
Boss Katana (50/100 MkII, Gen 3) settings