Skid Row · settings for Epiphone Les Paul Standard + Fender Hot Rod Deluxe IV
At zero: Drive · Master
2 of 10.
Glassy clean arpeggio tone on the Hot Rod Deluxe IV Clean channel with the bridge ProBucker, a slightly scooped bright EQ, and a touch of spring reverb standing in for the studio ambience. The chorus and delay are missing without pedals.
The signature wide shimmer on the clean arpeggios is absent.
Workaround: Try the coil-split bridge pickup with more reverb for extra width.
Arpeggios lose their spacious trails.
Workaround: Raise the amp reverb slightly to about 3.
Slightly less precise pre-amp tone shaping.
Workaround: Use the amp's middle and presence controls.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Steinberger, EMG-equipped (forum claim) → PEQ-3 Parametric EQ → ADA MP-1 preamp (v1.0, unmodified) into McIntosh 2100 power amp → Vintage Marshall 4x12 with Celestion G12H 30W
Amp effects: chorus (MP-1 built-in stereo chorus; the audible wide chorus on the clean arpeggios is most likely this (rate ~3, depth ~5, estimated))
Simple chord shapes; the challenge is clean, even arpeggios and a convincing clean-to-crunch switch.
Every song already dialed in for the Fender Hot Rod Deluxe IV.
Fender Hot Rod Deluxe IV settings