Skid Row · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Tremolo Speed · Tremolo Intensity
Twin Reverb can't reach MP-1 high gain without a pedal. Closest: bridge ProBucker into a loud, pushed Vibrato channel for a thick, barely-breaking-up lead, with a touch of reverb standing in for the studio delay smear.
Without any drive, the lead stays clean and loses all sustain and singing saturation.
Workaround: Crank amp volume to 7-8 and dig in hard for natural tube compression; coil-split off for max output.
Solo sits less forward in the mix without the mid bump and level boost.
Workaround: Use amp Middle at 6.5 and bridge tone at 8 to emulate the mid push.
Less depth behind sustained bends.
Workaround: Amp reverb at 2-3 gives similar subtle ambience.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Jackson Soloist-style guitar (bridge humbucker) → Ibanez Tube Screamer → MXR Six-Band Graphic EQ → A/DA MP-1 preamp → McIntosh solid-state power amp → Marshall 4x12 cabinet → studio delay (console/rack)
Technically moderate, but the tone lives in vibrato width and bend accuracy; only the closing run demands real speed.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings