Skid Row · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume
2.5.
Ultra Gain OD1 on the DSL40CR gets close to the MP-1's bright late-80s lead voicing. Bridge ProBucker full up, tone backed slightly, amp reverb low for the studio ambience behind sustained bends.
Sustained bends lose a little depth and smear.
Workaround: Use amp reverb at 2-3 in place of the low-mix delay.
Slightly less tight low end and front-end sustain.
Workaround: Raise Ultra gain to about 7 and keep bass at 4 to mimic the tightening.
Solo sits a bit less forward in the mix.
Workaround: Nudge Middle to 6.5 and leave the tone shift button disengaged.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Jackson Soloist-style guitar (bridge humbucker) → Ibanez Tube Screamer → MXR Six-Band Graphic EQ → A/DA MP-1 preamp → McIntosh solid-state power amp → Marshall 4x12 cabinet → studio delay (console/rack)
Technically moderate, but the tone lives in vibrato width and bend accuracy; only the closing run demands real speed.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings