Pierce the Veil · settings for Epiphone Les Paul Standard + Fender Frontman 10G
No effects needed for this part.
High-gain Marshall riff squeezed into a 10W solid-state Frontman. Bridge ProBucker, Overdrive switch on, gain high but not maxed to avoid fizz, treble up for pick attack, bass pulled back so fast palm mutes stay tight.
Without it the low end stays loose and the amp lacks the tightened mid push.
Workaround: Roll bass down to 3-4, keep gain just under max, and pick closer to the bridge for tightness.
Tone sounds dry and close compared to the record.
Workaround: Play in a live-sounding room or add reverb at the recording/DAW stage.
Melodic overdub layers lose stereo-ish width.
Workaround: Skip it on the main riff; the core part is essentially dry.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Guitar (bridge humbucker) → Overdrive boost → Marshall JMP 1959 Super Lead (modded) → Marshall 4x12 cabinet → Studio reverb/delay in the mix
The riff is not technically extreme, but needs accurate right-hand muting and tempo control to stay tight.
Every song already dialed in for the Fender Frontman 10G.
Fender Frontman 10G settings