Pierce the Veil · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
The JCM800 is a close cousin of Perry's modded Super Lead. Run the High input with preamp pushed, bridge ProBucker, mids present, tight bass. Without an overdrive out front the low end stays slightly looser, so trim bass and ride the guitar volume.
Low end is looser and the riff less focused under fast palm mutes.
Workaround: Lower Bass to 4 and push Pre-amp to 8+, pick nearer the bridge for tightness.
Riff sounds drier and more upfront than the record.
Workaround: Play in a live-sounding room or add reverb at the DAW/mix stage.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Guitar (bridge humbucker) → Overdrive boost → Marshall JMP 1959 Super Lead (modded) → Marshall 4x12 cabinet → Studio reverb/delay in the mix
The riff is not technically extreme, but needs accurate right-hand muting and tempo control to stay tight.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings