Avenged Sevenfold · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
JCM800 into the High input, preamp near max for Uberschall-level saturation, mids kept up for Syn's cutting lead. Bridge ProBucker full up, tone backed slightly. No pedals owned, so boost, delay and gate are the gaps.
Without a boost the JCM800 is less tight and the lead has less sustain and level over the band.
Workaround: Run preamp at 9-10 and keep bass low; pick harder near the bridge for attack.
Fast legato lines lose the smear and depth that make the solo sound big.
Workaround: Let notes ring and use wide vibrato for perceived sustain; lean on room ambience.
Hiss and hum between phrases at this preamp setting; stops are less tight.
Workaround: Mute with the picking-hand palm and left-hand fingers during rests.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (Invader); neck/Sustainiac for sustained bends
Schecter Synyster Gates Custom (Invader bridge) → MXR MC401 Boost/Line Driver → Noise gate → Delay → Bogner Uberschall 120W head → 4x12 cabinet with Vintage 30s → Studio reverb (mix)
Synyster Gates' lead mixes rapid picked runs with arpeggiated shred phrasing; clean execution needs strong picking-hand sync and controlled vibrato at speed.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings