Pantera · settings for Epiphone Les Paul Standard + Boss Katana (50/100 MkII, Gen 3)
At zero: Fx · Delay
Treble Booster / Mid Boost type, level ~9 o'clock.
Chorus or slow Flanger, depth low, rate slow, low mix.
Room, short, very low mix.
Noise Suppressor, threshold just above hiss.
Katana in Lead mode gets close to the Randall's brittle solid-state high gain. Use the bridge ProBucker, scoop the mids slightly, push treble, and add a touch of subtle mod for the doubled lead width. No reverb/delay beyond a hint.
Less of the signature scoop-and-bite plus gain push into the amp
Workaround: Use Katana Middle at 3-4 and Treble 8, plus the Booster block; Tone Studio adds an EQ block
The stacked octave/harmony sheen on the final squeal cannot be reproduced
Workaround: Play the ending squeal higher on the neck and lean on pinch harmonics plus vibrato for the screaming effect
No parked-wah mid bump on lead accents
Workaround: Nudge Middle up slightly for accented lead phrases
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge
Dean ML (bridge Bill Lawrence L-500XL) → Dunlop Cry Baby Wah → Furman PQ-3 Parametric EQ → MXR Six-Band Graphic EQ → Rocktron Hush 2-B / Boss NF-1 noise gate → MXR M-126 Flanger/Doubler → DigiTech Whammy (solo ending only) → Randall RG-100ES head → Randall 4x12 cabinet
The notes are not fast, but the solo lives on Dime's vibrato, bend intonation and squeal placement; nailing the feel and the layered ending is the hard part.
Every song already dialed in for the Boss Katana (50/100 MkII, Gen 3).
Boss Katana (50/100 MkII, Gen 3) settings