John Mayer · settings for Squier Stratocaster + Marshall MG30GFX
Edge-of-breakup Dumble-style lead on a solid-state Marshall: Crunch channel just barely dirty, neck pickup, mids up to fatten the bright ceramic Squier, a touch of amp reverb and a faint delay under the lead.
Loses the transparent thickening and sustain that lifts the lead above the verse.
Workaround: Use the Crunch channel's own breakup and dig in harder; raise guitar volume to 10 for the lead.
No mid-hump push for solo lift; lead sits flatter in the mix.
Workaround: Middle at 7 provides the mid bump; nudge guitar volume up for the lift.
Sustained bends decay faster and note volume is less even.
Workaround: Pick consistently and use vibrato to sustain; the Crunch channel compresses slightly on its own.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck pickup (position 1), some players use neck+middle
Fender Custom Shop Stratocaster "Black1" (Big Dipper pickups) → Keeley-style compressor → Klon Centaur → Ibanez Tube Screamer → Analog delay → Two-Rock Custom Reverb Signature → Two-Rock 2x12 cabinet
Amp effects: reverb (Two-Rock Custom Reverb Signature has onboard spring reverb; set low for a soft halo, likely supplemented by studio plate)
The notes are not fast, but exposed slow bends, controlled vibrato and microdynamics at near-clean gain make it unforgiving.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings