John Mayer · settings for Squier Stratocaster + Yamaha THR10II
Delay/Reverb type, time ~300 ms, low feedback, mix low.
Spring reverb, low depth.
Edge-of-breakup Dumble-style lead on a desktop modeler: THR10II Clean mode pushed near breakup, neck pickup, mids up, a touch of delay/reverb for depth. Guitar volume and pick attack do the dynamics, since no overdrive pedals are available.
Loses the thickened, lightly saturated midrange push and sustain on bends
Workaround: Raise Clean mode gain to 7 and middle to 7, dig in with the pick; back guitar volume to clean up
No extra mid-hump lift for the lead peak
Workaround: Switch to Crunch mode with gain 4 for the loudest lead phrases
Less evened-out sustain on slow wide bends
Workaround: Control dynamics with picking hand and guitar volume; THR modeling compresses slightly on its own
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck pickup (position 1), some players use neck+middle
Fender Custom Shop Stratocaster "Black1" (Big Dipper pickups) → Keeley-style compressor → Klon Centaur → Ibanez Tube Screamer → Analog delay → Two-Rock Custom Reverb Signature → Two-Rock 2x12 cabinet
Amp effects: reverb (Two-Rock Custom Reverb Signature has onboard spring reverb; set low for a soft halo, likely supplemented by studio plate)
The notes are not fast, but exposed slow bends, controlled vibrato and microdynamics at near-clean gain make it unforgiving.