Bullet for My Valentine · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
DSL40CR Ultra Gain OD2 gets close to the 5150's tight high gain. Bridge ProBucker full up, mids pulled back with tone-shift off, resonance up for drop-C weight, no reverb. Palm-mute discipline replaces the missing boost and gate.
Low end stays looser and mids less focused than the record's tight chug.
Workaround: Lower bass to 4-5 and keep Ultra gain near 7 so the preamp stays tight; mute hard at the bridge.
High-gain hiss and ringing between stabs instead of hard-stopped silence.
Workaround: Mute with the picking-hand palm and left-hand fingers on every rest; roll bridge volume down between takes.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge
ESP/LTD guitar with EMG 81 bridge → Maxon overdrive → Boss NS-2 noise suppressor → Peavey 5150 head (lead channel) → Mesa/Boogie 4x12 slant cab → SM57 + MD421 into Neve 1073
Intermediate: shapes are simple power chords, but the tempo demands clean, even picking and disciplined muting to keep the chugs tight.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings