Bullet for My Valentine · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
JCM800 High input with the pre-amp pushed hard gets close to the 5150's bite, just with more upper-mid Marshall grind. Bridge ProBucker in full humbucker mode; no overdrive out front, so tighten the low end with the Bass knob and strict palm muting.
Without it the drop-C chugs lose low-end tightness and mid push; riffs sound looser and woollier.
Workaround: Run preamp near max, pull Bass back to 4, and mute hard at the bridge to fake the tightening.
High-preamp JCM800 hiss and feedback bleed between stabs; chug stops are less abrupt.
Workaround: Mute strings with the picking-hand palm and fretting-hand fingers immediately after each stab.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge
ESP/LTD guitar with EMG 81 bridge → Maxon overdrive → Boss NS-2 noise suppressor → Peavey 5150 head (lead channel) → Mesa/Boogie 4x12 slant cab → SM57 + MD421 into Neve 1073
Intermediate: shapes are simple power chords, but the tempo demands clean, even picking and disciplined muting to keep the chugs tight.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings