Dokken · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD1 on the DSL40CR gives a hot-rodded, boosted-Plexi crunch. Keep gain moderate, mids forward and tone shift off. Use the bridge ProBucker on full humbucker with reverb off. The missing TS808 boost is covered by gain and EQ.
Less low-end tightening and midrange push into the preamp.
Workaround: Lower bass, boost middle, and keep Ultra gain moderate instead of maxing it.
Loses the subtle slapback ambience under the riff.
Workaround: Play it dry; the ambience is barely audible under the riff.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
ESP superstrat (Tiger/Kamikaze-era) or Charvel/Kramer, Floyd Rose, bridge humbucker → TS808 Tube Screamer (as boost) → Echoplex EP-2 tape echo → Lee Jackson-modded Marshall Plexi 100W, blended with a Randall RG-series head → Marshall 4x12 with Celestion Greenbacks
Riff is mostly power chords and palm-muted eighths, but the record's punch comes from precise muting and tight stereo doubles.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings