Metallica · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Reverb · Tremolo Speed · Tremolo Intensity
No effects needed for this part.
A Twin Reverb with no pedals can't reach thrash saturation. Set up the brightest, tightest clean platform with the bridge ProBucker, volumes high for a touch of breakup, and treat this as a stand-in until a high-gain pedal is added.
Without a drive pedal the Twin stays clean; no sustain, no saturation, the solo will not read as thrash.
Workaround: Crank volume to 7-8 and dig in hard for the loudest clean-edge tone; the notes are there but the character is not.
No front-end boost to tighten the low end and push lead sustain.
Workaround: Keep bass moderate and pick near the bridge for tightness instead.
Loses some of Hammett's vocal lead inflection on a few phrases.
Workaround: Use the bridge tone knob rolled between 6 and 9 for a crude parked-wah color.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Jackson Randy Rhoads Flying V (EMG 81, bridge) → Dunlop Cry Baby Wah → Ibanez TS9 Tube Screamer → Mesa/Boogie Mark IIC+ (lead mode, graphic EQ) → modded 100W Marshall power amp → Marshall 4x12 cabinet → Shure SM57s
The solo demands fast picking, aggressive bends and whammy work at high gain, where noise control and clean articulation are as hard as the notes themselves.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings