Metallica · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD2 on the DSL40CR with a scooped Marshall EQ gets close to the Mark IIC+ lead voice. Bridge ProBucker full up, tone open, no reverb. Without a Tube Screamer the low end is looser, so keep gain moderate and pick hard.
Without the front-end boost the low end is looser and leads have less focused sustain.
Workaround: Lower gain_ultra to ~7, cut bass to 5 and raise treble/presence to recover tightness and cut.
Loses the occasional vocal mid-sweep in lead phrases; barely audible in this solo anyway.
Workaround: Fake a parked-wah bump by nudging middle up slightly for those phrases.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Jackson Randy Rhoads Flying V (EMG 81, bridge) → Dunlop Cry Baby Wah → Ibanez TS9 Tube Screamer → Mesa/Boogie Mark IIC+ (lead mode, graphic EQ) → modded 100W Marshall power amp → Marshall 4x12 cabinet → Shure SM57s
The solo demands fast picking, aggressive bends and whammy work at high gain, where noise control and clean articulation are as hard as the notes themselves.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings