The Killers · settings for Epiphone Les Paul Standard + Fender Frontman 10G
No effects needed for this part.
Bridge ProBucker into the Frontman's overdrive channel, dialed to mid-forward crunch rather than high gain. No delay or overdrive pedal available, so the lead leans on the humbucker's midrange and a slightly rolled tone knob for a smoother, cutting single-note voice.
Lead sounds dry and narrow without the subtle dotted-eighth repeats and width.
Workaround: Let notes ring full length and add light vibrato to simulate sustain and movement.
Lead loses the mid hump and smooth compression that let it cut over the rhythm bed.
Workaround: Use the amp's overdrive switch with gain at 5 and treble up; pick firmly for bite.
Slightly flatter, more upfront lead without the light ambience.
Workaround: Play in a reflective room or add reverb later if recording.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Ibanez Destroyer → Overdrive (Tube Screamer style) → Delay (short, low-mix repeats) → Fender Hot Rod DeVille 2x12 combo → 2x12 combo speakers
Amp effects: reverb (Hot Rod DeVille has spring reverb; used sparingly, most ambience is from the mix)
The lead is short and melodic with no fast runs; the challenge is clean bends, consistent vibrato and sitting in time over the busy rhythm part.
Every song already dialed in for the Fender Frontman 10G.
Fender Frontman 10G settings