The Killers · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
JCM800 High input with the Les Paul bridge humbucker gets a mid-forward crunch close to the DeVille's driven channel. Preamp moderate, treble and presence up for the chimey cutting edge, master as loud as allowed. No delay or reverb available, so the lead sits drier than the record.
Lead sounds drier and narrower; loses the washed width of the record.
Workaround: Let notes ring full value and add vibrato for sustain; keep phrasing legato to fake the tail.
Slightly less mid push and compression into the amp front end.
Workaround: Preamp at 5 with Middle 6.5 on the High input approximates the mid-focused lift.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Ibanez Destroyer → Overdrive (Tube Screamer style) → Delay (short, low-mix repeats) → Fender Hot Rod DeVille 2x12 combo → 2x12 combo speakers
Amp effects: reverb (Hot Rod DeVille has spring reverb; used sparingly, most ambience is from the mix)
The lead is short and melodic with no fast runs; the challenge is clean bends, consistent vibrato and sitting in time over the busy rhythm part.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings