Deftones · settings for Epiphone Les Paul Standard + Line 6 POD Go (direct)
Tight gating between riff hits.
Dry full. Only for riff weight.
Cut 500 Hz by 4 dB (Q 1.2), +3 dB at 2.5 kHz, high-pass 80 Hz.
Decay low, Pre-delay 10 ms.
POD Go direct: PV Panama (5150) model for tight, mid-scooped high gain approximating the A/DA MP-1 into a Marshall power amp, with a 4x12 cab IR, sub-octave, gate and a touch of room reverb. Bridge humbucker, everything wide open.
Loses the extra grind/saturation layered over the preamp distortion on heavy hits.
Workaround: Use the POD Go's Triangle Fuzz block in a snapshot before the amp at low level, or simply push amp Drive a touch higher; with only 6 blocks you may drop the Pitch block to fit it.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
ESP Stephen Carpenter signature (Seymour Duncan JB bridge) → Boss OC-2 Octave → Boss FZ-2 Hyper Fuzz → A/DA MP-1 tube preamp → Rocktron Intellifex → Marshall 9200 power amp → Marshall 1960 4x12 cabinet
The riff itself is easy to fret; the challenge is groove placement, muting the drop-tuned low string cleanly and matching the heavy, even attack.